Who wires patio heaters in Leeds?Martin Day Electricians: a dedicated outdoor circuit, usually done in one visit
You get a patio heater running from its own RCD-protected outdoor circuit with a local isolator by the heater, certified as notifiable Part P work, instead of an extension lead trailed across damp paving.
The short answer
You need a dedicated, RCD-protected outdoor circuit from your consumer unit, not an extension lead trailed outside. Most patio heater circuits are completed in a single visit by an NICEIC Approved Contractor, with a written estimate before work starts, then certified as notifiable Part P work.
- NICEIC Approved Contractor
- Part P registered
- JIB Approved
- On the Register of Electricians
- £5,000,000 public liability
How do I know I need this?
Running a patio heater off an extension lead trailed across damp paving or lawn risks tripping the circuit, damaging the cable or an electric shock, especially when left running for hours in the rain.
You notice
- A patio heater running off an extension lead through the door
- The circuit tripping when the heater has been on a while
- A cable trailed across damp paving or the lawn
- Nowhere to switch the heater off without going back inside
It's costing you
- Evenings cut short every time the power trips
- A cable slowly being damaged underfoot
- A shock risk when it runs for hours in the rain
And if you leave it
- A damaged lead that becomes a shock risk
- Uncertified outdoor wiring to explain to a buyer or insurer
- A temporary setup that quietly becomes permanent
How the job is done
The same sequence on every job, so you know what happens and when.
We size the circuit to the heater's load
A separate circuit is run from your consumer unit to wherever the heater sits, sized for its actual load, not shared with sockets already doing another job.
We fit weatherproof, IP-rated kit throughout
Cable, sockets and any switching are all rated for outdoor use and sealed against the rain and damp a Leeds garden gets more of than most rooms indoors.
We add RCD protection and a local isolator
Every outdoor circuit gets RCD protection so a fault outside trips safely, plus an isolator near the heater so it can be switched off at the point of use.
We certify it as notifiable Part P work
A new outdoor circuit is notifiable under the Building Regulations, and every job is certified on completion, a proper record if you ever sell or let the house.
You send the details, we estimate, you decide.
Electrician, handyman or national chain?
What you get from each, side by side.
| What you get | Martin Day Electricians | Local handyman | National chain |
|---|---|---|---|
| NICEIC-certified electrical work | Approved Contractor, certificate issued | Rarely certified | Depends on the subcontractor sent |
| Part P notification where required | Handled for you | Usually not possible | Often a chargeable extra |
| How the heater gets its power | Dedicated circuit from the board | Nearest socket or a lead | Standard kit, standard run |
| Switching off at the heater | Local isolator fitted outside | Back inside to unplug | Not part of the package |
| Who turns up | Martin's own local team | One person, no cover | Whoever is allocated |
| Written estimate | Before any work starts | Often verbal | Varies |
| Insured and guaranteed | £5,000,000 public liability, guaranteed | Check case by case | Via head office |
More about patio heating systemsWhat the job involves, the regulations that apply and related work
What a patio heater installation involves
We run a separate circuit from your consumer unit to wherever the heater sits. Every part of the installation is specified for outdoor use:
- A dedicated circuit - sized for the heater’s actual load, not shared with sockets already doing another job.
- RCD protection - fitted on every outdoor circuit, so a fault outside trips safely rather than putting the rest of the house at risk.
- Weatherproof, IP-rated fittings - cable, sockets and any switching are all rated for outdoor use and sealed against the rain and damp a Leeds garden gets more of than most rooms indoors ever do.
- A local isolator switch - added near the heater where it helps, so it can be turned off at the point of use rather than sending someone back inside every time.
The same principles apply whether the heater sits under a pergola, on an open patio or close to a hot tub or outdoor kitchen: the right cable rating, the right IP-rated fittings and a circuit that is isolated and protected on its own, not tacked onto whatever socket happened to be nearest.
How long does the work take?
Most patio heater circuits are completed in a single visit. We give you a written estimate after studying the photographs and information you send us. An estimate is our best assessment of the job. It is not a fixed price. If we find something that couldn’t be seen at the start, such as a hidden fault, we will tell you what we have found and what it means for the price before carrying on.
Does patio heater wiring need certifying?
Yes. A new outdoor circuit is notifiable work under Part P of the Building Regulations, and every job is certified once complete. That gives you a proper record if you ever sell the house or need to show a landlord or insurer the work was done to standard.
Why book Martin Day Electricians
Martin Day Electricians has been wiring Leeds homes and gardens for more than 30 years, built on straightforward, well-finished outdoor work rather than anything flashier.
Can other garden electrics be done at the same visit?
Gardens rarely need just one job. We regularly fit garden sockets, security lighting and outdoor air conditioning alongside a patio heater circuit, particularly in gardens across Adel, Roundhay and Horsforth, where larger plots often mean more than one exterior job worth doing together. We cover Leeds and the surrounding areas more widely too.
Get in touch with photographs and details of the job for a written estimate. See our full guide to electrician costs in Leeds for how our pricing works across every service, or contact us directly.
Related services
- Garden electrical sockets - weatherproof outdoor sockets and garden circuits, often fitted alongside a patio heater circuit as one exterior job.
- Security lighting - PIR and dusk-to-dawn lighting for driveways and gardens, fitted to current regulations.
- Air conditioning wiring - dedicated circuits for domestic air conditioning, part of the same exterior comfort-electrics bundle.
What Leeds customers say
Read all 268 reviewsRated 5 out of 5
Completed the EICR and remedial work to a great standard, leaving the property safe and tidy. Would happily use again and recommend.
Rated 5 out of 5
Martin was excellent. Carried out my EICR for my retail shop in a very professional manner. Really nice bloke to deal with. Many thanks.
Get an estimate for patio heating systems
Tell us what is happening and where, and send photographs if you can. We come back with a written estimate, and a certificate at the end where the work needs one.
Martin Day
Owner, NICEIC Approved Contractor
Or Martin's mobile: 0780 847 7707
Send an enquiry
We use your details only to reply to your enquiry and to arrange any work. They are never sold or shared for marketing. See our privacy policy.